Showing 49–56 of 56 results
-
3/8″ NPT Stainless Steel Weld-On Bung for IAT or CLT Sensor
$12.993/8" NPT Stainless Steel Weld-On Bung for IAT or CLT Sensor Our 3/8" pipe fitting for temperature sensors is now available in stainless steel. This one can be welded to either stainless or mild steel. Comes with galvanized steel plug as well.
Add to cart -
O2 sensor adapter/flange for Toyota applications
$14.99While most oxygen sensors use an M18 threaded mount, many Toyotas from the '80s through the early '90s used a two bolt flange to install their O2 sensors. Our Toyota style adapter flange allows you to swap in a wideband oxygen sensor without welding in an...
Add to cart -
MSPNP and DIYPNP IAT Sensor Kit – Steel Bung
$39.99MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart -
IAC Valve Pigtail (6″)
$8.00IAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cart -
IAC Valve Connector with Crimp Terminals
$6.50IAC Valve Connector (Uncrimped) Complete with the connector, four pins, plus an extra pin (just in case)
Add to cart -
TPS Connector (GM 3 Pin Style)
$6.50TPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cart -
3/8″ NPT Aluminum Weld-On Bung for IAT or CLT Sensor
$9.493/8" NPT Aluminum Weld-On Bung for IAT or CLT Sensor Bung is 6061-T6 aluminum alloy; the included plug is galvanized steel.
Add to cart -
TPS Pigtail (GM 3 Pin Style)
$8.00GM Style 3-pin TPS Pigtail used in many GM applications, as well as others.... 6" Pigtail, pre-crimped, ready for your harness.
Add to cart