Cart

Quick Links

MSPNP2 Accessories

EPA, CARB, Race Use Only Disclaimer

Accessories to make your MSPNP-Gen2 MegaSquirt install a breeze.

Showing all 8 results

  • AXM-100 High Voltage Tach Adapter

    $65.00

    Many older tachometers trigger off the negative terminal of the ignition coil.  Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...

    Add to cart
  • USB to Serial Adapter – Trouble Free!!

    4.7142857142857 out of 5
    $22.50

    This USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purchase, so we high...

    Add to cart
  • Electronic Boost Control (EBC) Solenoid Kit

    $58.00

    This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...

    Add to cart
  • DB15 Pigtail Harness

    $20.00

    DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).

    Add to cart
  • DB26 Pigtail Harness

    $20.00

    DB26 pigtail connector, as used with the latest MSPNP Gen 2 for its 26 pin expansion connector. Includes 6" pre crimped wires. Poke in the ones you need, leave out the ones you don't.

    Add to cart
  • Y Vacuum Fitting

    $1.50

    1/8" vacuum Y-fitting, as included in the MSPNP and Mustang plug and play packages. This is made of clear polycarbonate. Maximum pressure 125 psi. This plastic is tough enough to take 275 degree F engine temps, and won't crack even if exposed to Siberian ...

    Add to cart
  • MSPNP and DIYPNP IAT Sensor Kit – Steel Bung

    $29.00

    MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...

    Add to cart
  • MSPNP and DIYPNP IAT Sensor Kit – Aluminum Bung

    $29.00

    MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...

    Add to cart