$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart
IAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cart
Bosch Style Fuel Injector Plug with 6" Wire Pigtail Fits a wide variety of cars that use Bosch injectors, including many Ford, GM, and BMW products. This fuel injection connector also fits many Bosch temperature sensors. This connector incorporates sea...
Add to cart
TPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cart
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Reviews
There are no reviews yet.