$23.99
-
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
This tool makes de-pinning Weather Pack connectors a simple snap or poke. Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart
This 5 wire pigtail connector fits 5 wire type GM MAF sensors from 1985 to 1989, as well as IGN1A coils and some GM DIS modules. Replaces GM part number 12085497. Note that we only have a few of these left in stock, when they are gone we w...
Add to cart
Wire - Twin Core Shielded 22 Gauge - 10' Shielded twin core 22 gauge wire helps cut out interference -- Perfect for Tach/Ignition Signal! This temperature resistant wire has two separate 22 gauge wires in the shield, making it perfect for variable relu...
Add to cart
IAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cart
Reviews
There are no reviews yet.