$29.99
-
Out of stock
Optional, connect MS3Pro ULTIMATE directly to your laptop with this 4 pin M12 serial cable.
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cart
We've wrapped a 10K, 1/4 watt resistor in a sealed and strain-relieved package for underhood use. Red heat shrink tubing with yellow leads. Typically used as a shunt resistor with VR sensors.
Add to cart
If you have a previously installed MS3Pro harness (1st Gen) and want to change to an MS3Pro ULTIMATE or EVO ECU, the upgrade path is simple. However, complete functionality will require a few basic changes to your 1st Gen harness. Our wiring upgrade ki...
Add to cart
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
We've wrapped a 1K, 1/4 watt resistor in a sealed and strain-relieved package for underhood use. Blue heat shrink tubing with blue leads. Suggested uses include a pull-up resistor for Hall effect and optical sensors, and pull ups for VSS or other 0-12 vol...
Add to cart
Reviews
There are no reviews yet.