$4.50
-
We’ve wrapped a 10K, 1/4 watt resistor in a sealed and strain-relieved package for underhood use. Red heat shrink tubing with yellow leads. Typically used as a shunt resistor with VR sensors.
There are no questions yet, be the first to ask something for this product.
MicroSquirt Engine Management System with Connector & Pins Version 3.0 The versatile MicroSquirt: Standalone Engine Management System, Transmission Controller or CAN I/O Expansion Module Microsquirt is our entry-level fully assembled ECU with v...
Add to cart
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cart
MS3Pro ULTIMATE adds nearly 50% more I/O with the addition of a third AMPSEAL 23-pin, 8' flying lead. Harness arrives with color-coded, printed wires per the pinout below (black center connector) ***Center Harness ONLY in this listing, intended for p...
Add to cart
If you have a previously installed MS3Pro harness (1st Gen) and want to change to an MS3Pro ULTIMATE or EVO ECU, the upgrade path is simple. However, complete functionality will require a few basic changes to your 1st Gen harness. Our wiring upgrade ki...
Add to cart
Use this module to convert the sine wave signal from a VR (variable reluctor) signal into an easy to handle square wave. The AXM-120 VR conditioner works with camshaft position, crankshaft position, vehicle speed, or similar sensors. Common uses for thi...
Add to cart
The MS3Pro ECU’s feature user-replaceable fuses that protect against voltage spikes and other abuse. To replace these fuses, use a needle nose pliers to pull the fuse out of its holder, and then push in the replacement fuse by hand. These 500mA fus...
Add to cart