$4.50
-
We’ve wrapped a 10K, 1/4 watt resistor in a sealed and strain-relieved package for underhood use. Red heat shrink tubing with yellow leads. Typically used as a shunt resistor with VR sensors.
There are no questions yet, be the first to ask something for this product.
MS3Pro ULTIMATE adds nearly 50% more I/O with the addition of a third AMPSEAL 23-pin, 8' flying lead. Harness arrives with color-coded, printed wires per the pinout below (black center connector) ***Center Harness ONLY in this listing, intended for p...
Add to cart
Have an application with a lot of small solenoids that need 12V power and rapid switching? Don't want the expense of a bank of four separate solid state relays, each rated for five times the current each solenoid needs? This module lets you run up to four...
Add to cart
MicroSquirt Engine Management System with Connector & Pins Version 3.0 The versatile MicroSquirt: Standalone Engine Management System, Transmission Controller or CAN I/O Expansion Module Microsquirt is our entry-level fully assembled ECU with v...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
If you have a previously installed MS3Pro harness (1st Gen) and want to change to an MS3Pro ULTIMATE or EVO ECU, the upgrade path is simple. However, complete functionality will require a few basic changes to your 1st Gen harness. Our wiring upgrade ki...
Add to cart
Please note -- due to parts shortages, Microsquirt 8' harnesses are unable to ship until beginning of May 2021. We are very sorry for the delay! MicroSquirt Engine Management System with 8' Wiring Harness Version 3.0 The versatile MicroSquirt: Stan...
Add to cart