Description
MS3Pro EVO Complete 8′ Flying Lead Harness Only (White & Gray connectors with 8′ pigtails) arrives with color-coded, printed wires per the pinout below.
All applications.
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cartHave an application with a lot of small solenoids that need 12V power and rapid switching? Don't want the expense of a bank of four separate solid state relays, each rated for five times the current each solenoid needs? This module lets you run up to four...
Add to cartIf you have a previously installed MS3Pro harness (1st Gen) and want to change to an MS3Pro ULTIMATE or EVO ECU, the upgrade path is simple. However, complete functionality will require a few basic changes to your 1st Gen harness. Our wiring upgrade ki...
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartUse this module to convert the sine wave signal from a VR (variable reluctor) signal into an easy to handle square wave. The AXM-120 VR conditioner works with camshaft position, crankshaft position, vehicle speed, or similar sensors. Common uses for thi...
Add to cartWe've wrapped a 1K, 1/4 watt resistor in a sealed and strain-relieved package for underhood use. Blue heat shrink tubing with blue leads. Suggested uses include a pull-up resistor for Hall effect and optical sensors, and pull ups for VSS or other 0-12 vol...
Add to cart
Reviews
There are no reviews yet.