$28.99
-
DB26 pigtail connector, as used with the latest MSPNP Gen 2 for its 26 pin expansion connector. Includes 6″ pre crimped wires. Poke in the ones you need, leave out the ones you don’t.
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
DB15 pigtail harness. Used for the extra I/O capabilities of the MSPNP Gen2 with V1.2 PCB (the version with the red main board).
Add to cart
Black Ford TFI module connector. Note that this is not keyed the same way as the gray connector; the notch on the right side of this connector in the photo is on the left side of the gray connector. Check your module before ordering.
Add to cart
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
MegaSquirtPNP and DIYPNP IAT Sensor Kit - Steel Bung This is a simple kit to make it easier for you when removing your AFM/MAF when using a MegaSquirtPNP or DIYPNP. In many cases, the air temperature sensor is built into the MAF, so removing it will re...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
EV6 Style Fuel Injector Connector with 6" Wire Pigtail These fuel injection connectors fit many applications; among them several GM applications and the Dodge/Plymouth Neon/Charger/Challenger and others. The wire used is 18 gauge GXL high temperatur...
Add to cart
Reviews
There are no reviews yet.