$29.99
-
Out of stock
Optional, connect MS3Pro ULTIMATE directly to your laptop with this 4 pin M12 serial cable.
You must be logged in to post a comment.
There are no questions yet, be the first to ask something for this product.
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cart
MicroSquirt Engine Management System with Connector & Pins Version 3.0 The versatile MicroSquirt: Standalone Engine Management System, Transmission Controller or CAN I/O Expansion Module Microsquirt is our entry-level fully assembled ECU with v...
Add to cart
This electronic boost control solenoid can be used with the MS3-Pro/MSPNP2 or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. The MS3-Pro, MS3-Pro Plug and Play, & MSPNP2 can drive this direct...
Add to cart
The MS3Pro ECU’s feature user-replaceable fuses that protect against voltage spikes and other abuse. To replace these fuses, use a needle nose pliers to pull the fuse out of its holder, and then push in the replacement fuse by hand. These 500mA fus...
Add to cart
Please note -- due to parts shortages, Microsquirt 8' harnesses are unable to ship until beginning of May 2021. We are very sorry for the delay! MicroSquirt Engine Management System with 8' Wiring Harness Version 3.0 The versatile MicroSquirt: Stan...
Add to cart
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Reviews
There are no reviews yet.