Description
3/8″ NPT Aluminum Weld-On Bung for IAT or CLT Sensor
Bung is 6061-T6 aluminum alloy; the included plug is galvanized steel.
$9.49
-
3/8″ NPT Aluminum Weld-On Bung for IAT or CLT Sensor
Bung is 6061-T6 aluminum alloy; the included plug is galvanized steel.
You must be logged in to post a comment.
Should I use this bung or the stainless steel bung?
Do I need this if I am installing the sensor in a cast manifold or cast tubing?
There are no questions yet, be the first to ask something for this product.
Hall effect crankshaft or camshaft position sensor. This is a new version, distinguished by its red anodized aluminum housing. Threads are M12 and mounting nuts included. Runs off 5 to 24 volts, and gives a nice square wave so there's no variable voltag...
Add to cartConvert your Nissan CAS to a more MegaSquirt-friendly arrangement with our bolt in optical shutter wheel! This replaces the stock low-resolution Nissan trigger wheel that has four slits with a higher resolution 24-2 wheel crank trigger. Intended for use ...
Add to cartMild Steel oxygen sensor bung and plug set, weld on and go. Fits wide band oxygen sensors and most narrow band oxygen sensors. Standard M18 x 1.5 thread.
Add to cartBosch LSU 4.9 5-wire, wideband O2 sensor with 8' cable bundle Compatible with the LM-2, LC-2, and MTX-L, SCG-1, DLG-1, PSB-1, and PSN-1. NOTE: The latest generation widebands are compatible with both the Bosch LSU 4.2 and 4.9. Please note that the s...
Add to cartThis Window Mount will allow you to mount the LM-1 to your windshield giving your a better view of the display while tuning. This is a HUGE improvement over letting the unit bounce around or propping it up, or trying to hold it and tune at the same time. ...
Add to cart
Reviews
There are no reviews yet.