Quick guide instructions to installing FW on AMP Engine Management products
===========================================================================

Full instructions can be found through the documentation on
http://www.ampefi.com

1. If you are presently using a different code version on your device you
should save you settings.
e.g. File->SaveAs in TunerStudio.

2. Ensure you have TunerStudio v3.x or later installed.

3. The FW Loader cannot be used from a .ZIP file. 
You must EXTRACT the files before you run the loader. 

4. Run AMP FW Loader.exe 

5. Select the .hex file you wish to load

6. When upgrading, just connect using your existing project. Usually you will
need to "update Project ini" and browse to the ini file provided in this zip
file.

8. Note!! When first creating a tune, you MUST be connected to the device
'online' or open an existing MSQ file. If you start tuning offline with blank
settings you will create huge problems for yourself.

For support visit WWW.AMPEFI.COM or WWW.DIYAUTOTUNE.COM
